This is a design to be able to use a Radiall R141007000W BNC cable connector with a RG402/U compliant cable, especially designed for Belden Conformable 1673A.

• To assemble this connector you need a 3 pieces of the Radiall R1411007000W BNC connector:
  1. the pin
  2. the outer shell
  3. the nut
• Strip the last 5 mm of the cable and expose the internal conductor.
• Cut 2 mm of the outer braid and leave the insulator.
• Solder the pin
• Put the nut on the cable (you don't want to forget it on the table…)
• Put the adaptor
• Put the pin in its place in the outer shell
• Slide the adaptor in the outer shell; when in position solder the adaptor to the braid
• Tight the nut